How to set LCD-003

[leafmotor]

How to set LCD-003?

Press "sw/middle button" from LCD more than 2 seconds,then LCD-003 will display.
Press "up & down button" together more than 2 sconds until 72 is flashing ( 72 is kmh, if you hope works 20mph / 32kmh, press "down" to be 32)
Press "sw/middle" button one time to save,then 26 is flashing.. (26 is wheel size. )
Press "sw/middle" button one time to save,then kmh or mph is flashing..
Press "sw/middle" button one time to save

Press "up & down button" together,set P
P1 = 46 (the number of magnets)
P2 = 0 (0 for low speed motor,1 for high speed motor)
P3 = 1
P4 = 0
P5 = 15 (48V battery is 15, 36V battery is 12, 24V battery is 9)

Press "sw/middle" button one time to save
Press "up & down button" together,set C

After setting,press "sw/middle" button more than 2 seconds until be back.

---------------

There is a " 5 or 4 or 3 or 2 or 1 or 0" on the Left side of LCD-003.
* Be "0" – throttle & pedal assist NOT work.
* Be "1" – throttle works (If install pedal assist, pedal about 3 circels,then can drive motor to work)
* Be "2" – throttle works (If install pedal assist, pedal about 2.5 circels,then can drive motor to work)
* Be "3" – throttle works (If install pedal assist, pedal about 2 circels,then can drive motor to work)
* Be "4" – throttle works (If install pedal assist, pedal about 1.5 circels,then can drive motor to work)
* Be "5" – throttle works (If install pedal assist, pedal about 1 circels,then can drive motor to work)


If NOT install that pedal assist,ONLY use throttle to drive hub motor. But Should be 1 or 2 or 3 or 4 or 5.(Be 0,turn off throttle)